5" Gas Vent Base Support With Brackets

If the Gas Vent is required to be supported where it penetrates the floor/ceiling Support Plates should be applied. These square heavy gauge galvanised plates must be fixed through the corner holes...

Made from galvanised steel, wall support is designed to provide internal lateral bracing support off a wall or structure. Distance to combustible materials: 50mm. In addition to structural support,...

The Gas Vent Rafter Support is designed to be used between rafters to give lateral support to twin-wall flue where it exits the roof.   Distance to combustible materials (in mm): 50

The Gas Vent Guy Wire Bracket is a specific locking band which is used to connect guy wires (not included) from the pipe to the roof when the pipe extends 1.5 mtrs above the roof ...

Made from galvanised steel, wall support is designed to provide internal lateral bracing support off a wall or structure. Distance to combustible materials: 50mm. In addition to structural support,...

This is a fitting for connecting a Gas Vent to a flue liner. The flue liner then sits in the 60mm deep socket. Distance to combustible materials: 50mm. Designed to be secured into the top of a...

Aluminium Storm Collar should be fitted to the vent immediately above the Flashing. The Collars are a tight fit to the vent and should be sealed with the silicone sealant. Gas Vent lengths and...

An aluminium terminal/cap allows rapid exhaust of combustion products. Gas Vent lengths and fittings are available with the outer casing fabricated from galvanised steel. The flue liner is aluminium...

Fixed straight pipes are available in three lengths: 1000mm, 500mm and 330mm. Distance to combustible materials: 50mm. Vent pipe lengths and fittings must be installed with the male coupler upwards...