Accessories

225mm in length and 100mm (4") in diameter with damper. A Damper units allow you to reduce the draw on the through the flue therefore allowing you to reduce the heat output on the stove. This is...

These 4" Gas Clamp Plate are used to seal off the top of the flue stack and provide support for the liner. These plates come in two parts for installation.

This 100mm(4") in diameter Wall Bracket is for supporting the Stove pipes in our range. The Bracket features an enamelled ring to secure around the pipe and a 220mm (approx.) telescopic tubular rod...

225mm in length and 125mm (5") in diameter with damper. A Damper units allow you to reduce the draw on the through the flue therefore allowing you to reduce the heat output on the stove. This is...

PLEASE NOTE THE DIAMETER ADVERTISED REFERS TO THE INTERNAL MEASUREMENT OF THE FLUE, NOT THE EXTERNAL MEASUREMENT. This sleeve is used to protect the flue when going through a wall at a 45° pitch...

Used where there is a gap between the register plate and stove-pipe joint, in order to collect debris falling from the chimney void. Mechanically tightened onto flue pipe, providing support for the...

This Fixing Clamp is suitable for gas, oil and multi-fuel burning appliances. The clamp slides down the flexible chimney liner until it rests on the top of the chimney and supports the weight...

This Galvanised Steel Protection Sleeve is suitable for gas, oil and multi-fuel burning appliances.The sleeve slides inside the flexible liner to prevent crushing of the liner when the clamp is...

Galvanised Steel Top Plate. Suitable for gas, oil and multi-fuel burning appliances. Use in conjunction with top clamp and protection sleeve. Supports the top clamp at the top of the stack.

These 5" Gas Clamp Plate are used to seal off the top of the flue stack and provide support for the liner. These plates come in two parts for installation.

PLEASE NOTE THE DIAMETER ADVERTISED REFERS TO THE INTERNAL MEASUREMENT OF THE FLUE, NOT THE EXTERNAL MEASUREMENT. Used to connect two elements of the stack at the joints. Suitable for use with 5"...

Nose cones connect to the end of the flexible flue liner and are used to guide the flexible flue liner down the flue. Made from aluminium they are usually taped on to the liner as a temporary measure.